The water channel mold is mainly made of plastic and steel molds with various shapes. In the use of construction engineering, there are assembled and combined drainage channel templates, which are cement water channel shapes formed by mutual splicing and installation, and then they can be pre formed by pouring cement. There is also a single water channel steel mold made of mold steel, which is generally made of steel The length of a section is about 50cm, so it can be divided into dozens or hundreds of parts. It can not only improve the speed of normal use, but also save the time limit. Mold manufacturing is a basic cornerstone to support the development of China's manufacturing industry. Mold is an important process of manufacturing industry.
When we operate, we always use the water trough mold to operate according to the process. This is to ensure the quality of the prefabricated parts, so that they can be better produced. Therefore, we will process them according to the requirements. The production sequence of the prefabricated parts is pouring mud, vibrating operation, air drying and drying. After that, we can remove the mold after the mud has solidified. The model of the runner mould is naturally larger, and it will be safer when processing. The steel mould is generally heavy, and it will be more bulky after pouring mud. Therefore, it is not recommended to carry out its production outdoors. If the production is carried out in the prefabrication plant, there will be multiple vibration platforms that can be used to place the whole runner mold on the vibration platform. After the vibration treatment of the platform, the bubbles in the mud can be cleaned, and the prefabricated parts produced will be more solid. The vibration platform is not easy to move, so it will be placed in a fixed position when processing. The vibrator is suitable to be used in cast-in-place, because it is easy to carry and suitable for the operation of some molds with complex structure.