The water channel mold is a kind of mold product commonly used in road construction or water conservancy project, which can also be called drainage channel mold, water channel mold, ditch mold, water tank mold, etc. the general factory construction personnel will add 5mm thick horizontal and vertical reinforcement to the mold surface to reinforce the mold, so as to not only increase the service life of the mold, but also avoid multiple use of the mold After the phenomenon of no leakage, it can effectively bear the pressure from a large number of concrete when pouring concrete. Usually in the process of transportation and use, it is necessary to pay attention not to bump into the mold, which will cause unnecessary loss to the project and shorten the use time of the mold. Once the mold is damaged, it must be timely remedied, and contact the mold production factory for re production Mold: in the process of re manufacturing the mold in the mold manufacturing factory, in order not to delay the construction period, another mold with the same shape and size can be used to make the production channel.
The concrete can be poured after a layer of release agent is evenly applied on the assembled mold of the flow channel. Attention should be paid to the concrete to be used in advance. The concrete mixer should be used in advance to mix and mix evenly according to the specified proportion. After grouting, it is necessary to use vibrating rod to mix concrete slurry at a constant speed. This step is very important for the production and production of trapezoidal ditch prefabricated parts. If the vibration is not sufficient, there will be bubbles in the precast parts, which will lead to a layer of dense honeycomb holes on the surface of the prefabricated parts, which will greatly affect the aesthetics. At the same time, it will also cause the trapezoidal ditch with insufficient compressive capacity and easy collapse, After vibration, it can wait for it to solidify completely and dismantle the trapezoidal ditch mold.