The size of the drain mold is variable, mainly to allow customers to have a better choice, so when processing, we should also select the mold according to the construction environment on site, of course, we can also customize the mold in the factory. The customization of ovate drainage ditch mold is mainly to make the prefabricated parts show its effect better, and the mold customization needs to prepare the drawing, which is provided by the customer, because the produced mold needs to fit the site environment and meet the construction requirements. If the customer provides it, it can better carry out his production 。 Our factory has advanced technology for the production of ovate drainage ditch mold, which can guarantee the quality of the produced mold. However, before processing, the technical personnel will refer to the dimensions on the drawings, and then select the material. If the smaller mold is needed, the lower specification steel material will be selected for processing, and the price will follow Reduce, of course, the molding time of the mold is very fast, customers can rest assured to customize.
The operation process of prefabrication of the drainage channel mold is grouting, vibration and drying. The vibration platform is used for treatment of these three basic operations. It can always observe whether there are some particles floating on the surface of the slurry, and then take them out in time. And in the air, we must put the drain mold in a stable environment, and spray some water on the surface of the slurry, so as to prevent the mud from cracking in the process of solidification due to excessive drying. After that, we can start to air formally. Of course, before production, we should also brush the mold release agent inside the drain tank mold In this way, the qualified prefabricated parts can be taken out for construction when the formwork is removed.