Channel mold is a common mold in our life. It plays a very important role in road construction, farmland irrigation and water conservancy projects. So this kind of mold has become an indispensable mold in our life. Canal moulds, drainage canal moulds and flow canal moulds manufacturers in China began to use canals very early. In the past, the way we made canals was not to use canal moulds, but to use bricks. When irrigating farmland, we did not even use bricks. We directly excavated a very narrow canal to irrigate farmland. Although such irrigation can also play a role in irrigating farmland, but the flow rate is slow, most of the water flow will seep down to a large extent, not only irrigation time is long, but also wastes water resources. With the development of science and technology and the deepening awareness of environmental protection, we have intensified efforts to reform farmland irrigation equipment, through the canal model. The raw material of this kind of canal is sand and soil, which is very cheap, so the cost is very low. Moreover, the use of the canal greatly reduces the waste of water resources, and greatly improves the efficiency of irrigation. It can be said that it kills two birds with one stone. Mold industry needs continuous development, and constantly develop new or more suitable for life use of the mold.
Dimensions of canal moulds are varied, because in different environments, in order to better use the environment and play the best drainage effect in the environment, but also to ensure that within a certain cost, we need to make reasonable choices. Because when we make catchment tank mould, there are many materials to choose from. There are many choices just for one kind of steel material. The properties of different steels are different, because the corresponding size of the mould should be used. When we were making the canal moulds. If the mold is about two meters in size, we need to use 5 mm thick steel plate, so as to meet the actual production needs, if the size is very small in about half a meter, we can choose 3 mm steel to make panel, when making ribs, we need to use 4 mm steel.