Cable trough mold production of cable trough is mainly used in railway construction, this mold is generally made of a yellow ABS plastic, this material is relatively hard, so the wear resistance of this mold is relatively good. There are some special models of mold, the use of plastic production out of the mold can not be applied to production, so this kind of mold is generally made of steel plate. The specifications of our common high-speed cable trough mold are 900 * 500 * 375mm. Due to the increasing demand of people, the specifications of this mold are various. Large mold needs to bear more pressure when it is used, so the number of stiffeners or stiffeners on the surface of the mold is relatively large.
Now the types of high-speed cable tray mold are very rich, which can meet the needs of different environments, loads, spans and shapes. Customers can negotiate with manufacturers according to their own needs and customize the size and shape they need, which is very convenient. High speed cable trough mold now has a special anti-theft design, mold cover and frame will be connected by iron chain, anti-theft, safe and easy to open. Moreover, the strength of the high-speed cable trough mold after several improvements is better, and the strength and toughness are much higher than that of cast iron. The mould for cable tray is basically made of industrial steel plate, rarely made of other materials. 2. The thickness of these steel plates will not be less than 3 mm. Each steel plate is required to be uniform in thickness, and the gap can not exceed 1 mm. Generally speaking, the steel plate is poured with molten steel and then pressed instantaneously. The whole flat and smooth steel plate is formed. When making the mold, the steel plate can not be deformed or incomplete. Generally speaking, the initial selection of steel plate is complete and flat